Banks Power 2001-2005 Chevrolet 6.6L Duramax Turbo-Diesel Pickups - Manual (Page 14)

Figure 14
removed air filter minder and install
into the rubber grommet. Make sure air
filter minder is installed flush to rubber
grommet. See Figure 14.
15.
Locate the Banks Ram-Air filter
and the Banks filter hose clamp.
Loosely fit the Banks Ram-Air filter
clamp to the Banks Ram-Air filter. See
Figure 15.
Note: See Figure 16 to reference the
correct alignment locater grove to the
Banks Ram-Air filter.
16.
After verifying the correct
alignment between the Banks Ram-Air
filter and the Banks Ram-Air cover,
snap fit the two pieces together until
an audible snap is heard. This process
will ensure that a correct seal has been
established.
17.
Tighten the Banks Ram-Air filter
hose clamp to the Banks Ram-Air filter
cover.
18.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
See Figure 17. Locate the screws for
the Banks Ram-Air housing cover in
your kit. Align and loosely fit the Banks
Ram-Air cover onto the Banks Ram-Air
housing. Note: Use the Banks Ram-Air
cover and Banks Ram-Air housing to
fine tune alignment between Banks
Ram-Air intake tube and Banks Ram-
Air filter cover. The Banks Intake Tube
can be rotated to facilitate in alignment.
See Figure 18 and Figure 19.
CAUTIoN: Ensure Intake tube is not
touching any engine components,
specifically the boost tube and
intake manifold hose clamps.
19.
Tighten the upper (top) hose
clamp intake tube.
20.
Remove the Banks Ram-Air
housing cover screws and remove the
Banks Ram-Air housing cover. Note: Be
14
96453 v.3.0