Banks Power 2001-2005 Chevrolet 6.6L Duramax Turbo-Diesel Pickups - Manual (Page 8)

Figure 4
3.
Separate stock intake tube from
compressor inlet and remove the
stock intake tube from the engine.
4.
Remove Mass Air Flow (MAF) sensor
connector from stock air box filter
cover. Note: Be careful not to damage
the connector or the MAF sensor
during this process. See Figure 5.
5.
Remove stock air box by lifting the
air box up and out. The bottom of the
stock air box is held in place by rubber
grommets. There may be some slight
resistance when removing the stock
air box.
6.
Next, remove the stock air box
tray. Remove the bolts accessible from
the top of the engine compartment
as shown then remove the stock
air box tray. See Figure 6 . Keep
the previously removed bolts for
reassembly later in the installation
process.
7.
Locate your Banks Ram-Air filter
housing from your kit and install as
shown. Install housing and align Banks
Ram-Air filter housing holes with bolt
holes in engine compartment. Install
the previously removed stock air
box bolts to secure the Banks Ram-
Air filter housing. Do not tighten the
bolts at this time. Note: The cutout on
Banks Ram-Air filter housing must face
passenger side fender. See Figure 7.
8.
Locate your Banks Torx tool,T20H
in your Banks Ram-Air kit. Use the
Torx tool bit to remove the two (2)
screws securing the MAF sensor to
the stock air box cover See Figure
8. Note: careful when removing the
MAF Sensor. When removing the MAF
sensor, grasp its body and pull up
and out. Do not twist or bend when
removing.
8
96453 v.3.0