Banks Power 2001-2005 Chevrolet 6.6L Duramax Turbo-Diesel Pickups - Manual (Page 17)

Figure 19
careful not to disturb the alignment.
21.
Tighten the Banks Ram-Air filter
housing bolts to vehicle frame. See
Figure 20.
22.
Install the Banks bellows hose
and hose clamp onto the Banks Ram-
Air intake tube. See Figure 21.
23.
Loosely fit the hose clamp to the
other end of the bellows.
24.
Install the Banks Ram-Air cover
into bellows.
25.
Install Banks Ram-Air cover w/
filter after installing into bellows into
the Banks Ram-Air filter housing.
Note: a slight resistance in pressing
in the Banks bellows is normal. See
Figure 22.
26.
Now with the Banks Ram-Air filter
housing cover and Banks bellows fully
seated flush, fasten the Banks cover
to the Banks housing using the Banks
cover screws and tighten.
27.
Make sure that the Banks
bellows is flush with the Banks cover
connection bead and tighten the Banks
bellows hose clamp. Note: bellows will
need to be compressed slightly.
28.
connect MAF sensor connector
to intake tube. Note: you may have to
loosen wire harness clips, to increase
slack in length of wire harness available
to connect to intake air tube See Figure
23.
29.
Re-connect battery grounds.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 24. Make
sure to go over all hose clamps for
tightness and connectors for a sure
fit. Make sure that the intake tube is
not touching any engine components,
specifically the boost tube and intake
manifold hose clamps.
-END, SEcTION 2-
96453 v.3.0
17