Grain Systems PNEG-897 - Manual (Page 4)

1999 Top Dry Wiring Diagrams 1999 Top Dry Wiring Diagrams 1999 Top Dry Wiring Diagrams 1999 Top Dry Wiring Diagrams 1999 Top Dry Wiring Diagrams
4
Roof Damage Warning and Disclaimer
WARNING! BE ALERT!
Personnel operating or working
around electric fans should read this
manual. This manual must be
delivered with the equipment to its
owner. Failure to read this manual
and its safety instructions is a misuse
of the equipment.
The symbol shown is used to call your
attention to instructions concerning your
personal safety. Watch for this sym-
bol; it points out important safety pre-
cautions. It means "ATTENTION",
"WARNING", "CAUTION", and
"DANGER". Read the message and
be cautious to the possibility of per-
sonal injury or death.
Safety Alert Symbol
GSI DOES NOT WARRANT ANY ROOF DAMAGE
CAUSED BY EXCESSIVE VACUUM OR INTERNAL
PRESSURE FROM FANS OR OTHER AIR MOVING
SYSTEMS. ADEQUATE VENTILATION AND/OR
"MAKEUP AIR" DEVICES SHOULD BE PROVIDED
FOR ALL POWERED AIR HANDLING SYSTEMS.
GSI DOES NOT RECOMMEND THE USE OF DOWN-
WARD FLOW SYSTEMS (SUCTION). SEVERE
ROOF DAMAGE CAN RESULT FROM ANY
BLOCKAGE OF AIR PASSAGES. RUNNING FANS
DURING HIGH HUMIDITY/COLD WEATHER CON-
DITIONS CAN CAUSE AIR EXHAUST OR INTAKE
PORTS TO FREEZE.
Thank you for choosing a Top Dry Series 2000 unit.
It is designed to give excellent performance and
service for many years.
This manual describes the wiring for all stan-
dard production Top Dry Series 2000 single fan,
multi-fan and 2000 Series Heater Control units. Dif-
ferent models are available for liquid propane or
natural gas fuel supply, with either single phase 230
Fan/Heater Installation & Operating Instructions
SAFETY SAFETY SAFETY SAFETY SAFETY
As owner and/or operator, it is your responsi-
bility to know what requirements, hazards and pre-
cautions exist, and to inform all personnel associ-
ated with the equipment, or who are in the fan area.
Avoid any alterations to the equipment. Such alter-
ations may produce a very dangerous situation,
where serious injury or death may occur.
volt, or three phase 208, 220, 380, 460 or 575 volt
electrical power.
The principal concern of the GSI Group, Inc.
("GSI") is your safety and the safety of others asso-
ciated with grain handling equipment. This manual
is written to help you understand safe operating
procedures, and some of the problems that may be
en-countered by the operator or other personnel.