Grain Systems PNEG-1080 User Manual
Hilo kit installation, Pneg-1080
HILO Kit Contents
D03-0247
WIRE TIE 5"PANDUIT #PLT1.5M-M
EA
12
E106-1011
CRIMP,0.187"DISCONNECT SLIP-ON
EA
2
FH-7038
SEALTITE PVC 3/8"
EA
1
FH-7049
SEAL 3/8 STRAIGHT PVC W/NUT
EA
2
HF-7563
SEALANT TFE PIPE THREAD (3 OZ)
EA
1
TFH-2021
LIGHT RED NEON NO LEADS 125VAC
EA
1
WR-18BLK
WIRE 18 GA BLACK STRANDED
FT
1
WR-18WHT
WIRE 18 GA WHITE STRANDED
FT
1
HILO PIPETRAIN HILO PIPETRAIN
EA
1
1. Remove contents from HILO package and verify
that all contents are correct.
2. Remove TWO ½ NPT plugs from pipetrain on
heater. (Plugs A & B, Photo 1)
Plug A
Plug B
Photo 1
Photo 2
Close Nipple
3. Apply a sufficient amount of pipe thread sealer to
½ close nipple on outgoing side of solenoid valve
on HILO kit pipe train. (Photo 2)
4. Insert the Close Nipple (Photo 2) of the HILO
pipetrain into heater pipetrain where Plug B (Photo
1) was removed. Tighten HILO pipetrain securely to
heater pipetrain with a pipe wrench.
5. Apply pipe thread sealer to the ½ gas hose at the
opposite end of the HILO train.
6. Insert gas hose where Plug A (Photo 1) was removed
from the heater pipetrain. Tighten the hose securely
to the heater pipetrain.
7. Assemble conduit and fittings onto the solenoid valve
on the HILO pipe train.
8. Pull conduit and wires from solenoid up to control
box and mark where the hole location will be.
9. Drill a 7/8 hole in the control box at this location
and assemble conduit and wires through this hole.
10. Remove solenoid wire from terminal 8 (Photo 3) on
the circuit board and move it to terminal 10 (Photo
3).
31(*
PNEG-1080
HILO Kit Installation