Grain Systems PNEG-1080 - Manual (Page 2)

HILO Kit Installation
11. Place one of the red wires from the solenoid on the
HILO pipetrain on terminal 8 (Photo 3) and the other
red wire from that solenoid to terminal 5 or 6 (Photo
3). Place the green wire from the solenoid into one of
the ground lugs located in the bottom of the control
box.
12. You will now need to remove the black hole plug
from the front of the control box located under the
main indicator light. (see Photo 4)
13. Insert the red light into this hole.
14. Connect one side of the light to terminal 10 (Photo 3)
with the black wire and .187 female slip on provided
in the kit. Connect the other side of the light to termi-
nal 5 or 6 (Photo 3) with the white wire and .187
female slip on connector.
15. Your HILO kit is now installed. Be sure to check all
connections for secureness and check pipe train for
leaks.
Terminal: 1 2 3 4 5 6 7 8 9 10 Ground Lug
Photo 3
Photo 4
Hole Plug
PNEG-1080