Grain Systems Bin Flooring PNEG-223 User Manual
Page 10
Advertising
2. Recommended Method for Full Floor Installation
10
PNEG-223 60' Cor-Lok and Cut-Lok Flooring
6. Some floor planks will need to be spliced together.
Figure 7A on Page 17 and Charts on Page 18.)
Install plank length A first, then install
the corresponding plank length B by butting plank B up against plank A. Make sure the planks are
supported by a grandstand on each side of the splice. Continue until floor is complete. Center and
install floor splice plate (CLF-1763) over the splice seam using self drilling screws. Use three (3)
screws at the end of the splice and two (2) for each plank, one on each side.
Figure 2D
Advertising