Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1902 - Manual

Date: 12-14-12 PNEG-1902
Instructions
1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421
PNEG-1902
Page 1 of 7
Printed in the U.S.A.
Copyright © 2012 by GSI Group
www.gsiag.com
CN-301901
Discharge Gate Ground Control Kit
Chain Loop System - Ground Control Kit
Ground Control Kit for Discharge Gates
Determine the best location for each ground control kit. Note that each kit comes with 100' of cable, which
should be adequate for individual bin installations.
The cable idler pulley bracket is usually mounted at the top of the bin wall, just under the roof eave, in-line
with the control wheel on the discharge gate. The ground control wheel mounting bracket should be
mounted to the bin wall directly under the idler pulley bracket at a convenient operating height. It is
important to keep the cable in-line with the control wheels on both the discharge gate and at the ground
to avoid having the cable “walk off” the either wheel.
The ground control wheel can be mounted to the same bin as the discharge gate or to an adjacent bin.
See examples 1 and 2 in
Figure 1 .
Figure 1
Example 2
Controls mounted
on adjacent bin.
Example 1
Controls mounted on bin
where the discharge is located.