Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1902 - Manual (Page 2)

Page 2 of 7 PNEG-1902
Discharge Gate Ground Control Kit
Figure 2
1. Assemble the idler pulleys to the mounting bracket on the inside surface if the cable is going to a
discharge gate on the same bin. Assemble them on the outside if the cable is going to an adjacent
bin. Attach the idler pulley bracket to the bin wall just under the eave to ensure that the cable will
clear the bin roof.
(See Figure 3.)
Figure 3
Mounting bracket
(8101156)
Pulley (PT0550)