Grain Systems PNEG-833 - Manual (Page 4)

Important Safety Precautions: Dryer has sharp edges.
These sharp edges may cause serious injury.
Use appropriate Personal Protective Equipment.
Use proper lifting techniques.
Install the TOP AUGER TRASH SPREADER PAN under the top auger at the fill end of the dryer.
The first trash pan will actually begin approximately 8 inches from this end. Follow these instructions for proper placement.
Top Auger Trash Spreader Pan
Installation
1. Begin by starting on the fill end of the dryer. Mount the first trash pan bracket using the bottom bolt of the first safety handrail
mounting bracket and the bolt right below that (see picture above).
2. Measure the hole pattern of the first trash pan, because not all trash pan mounting bracket holes are the same distance apart. Use
the chart below for trash pan placement. Use the bolts that are spaced every 8 inches, just under the handrail, as one of the mounting holes
for the next trash pan bracket (most trash pan holes are 16 inches apart, but not all). If the next trash pan bracket is at a point that does
not have a handrail bracket then a 3/8” hole will have to be drilled 1” above the existing mount bracket hole.
3. After all the holes for the trash pan brackets are drilled bolt the brackets to the trash pan sections. If your kit has more than one
section do not bolt the bracket at the splice end to the trash pans until they have been mounted in the auger housing. After trash pans are
in place then lay your splice in the gap between the sections and then bolt the remaining brackets to the assembly. Remember that the
longest trash pan section starts at the fill end of the dryer then the next longest and so on (except in the case of 38’ dryers, see chart above).
Refer to the photographs on the next page to help you assemble the trash pan section.
8 ft 10 ft 12 ft 14 ft 16 ft 18 ft 20 ft 22 ft 26 ft 34 ft 38 ft
5' 7' 9' 7' 7' 7' 9' 7' 7' 7' 7'
3' 5' 7' 7' 7' 7' 7' 9'
3' 7' 7' 9'
7' 7'
DRYER BASKET LENGTH
Find the length of your dryer and follow that column down to find the
order in which the different length of trash pans are installed (starting
from the fill end of the dryer).
FILL END
SAFETY
HANDRAIL
SAFETY
HANDRAIL
BRACKET
TROUGH
SIDE
A
B
TRASH PAN BRACKET