Grain Systems PNEG-1860 - Manual (Page 5)

Cross Brace Installation to Legs at HITCH BRACKET
LOCATION
1. Install the leg stand X-brace bracket (B) to the tops and bottoms of the dryer leg stands
using bolts (C) and nuts (D). Brackets (B) should be installed so the large flat surface is
towards the hitch end of the dryer.
2. Attach the flat sides of the leg stand X-braces (A) between two legs from an upper and a
lower leg stand x-brace bracket (B). Make sure to use the bolt hole locations indicated for
the hitch cross brace installation and fasten with bolts (C) and nuts (D).
3. The flat sides of the leg stand X-braces (A) will cross each other in the center, fasten the
cross braces together at this center point with a bolt (C) and nut (D).
Callout Part Number Description
A D01–1773 Leg Stand X-Brace
B D01–1772 Leg Stand X-Brace Bracket
C S-7927 3/8”-16 x 1” YDP Grade 8 Flange Bolt
D S-968 3/8”-16 Grade 5 Wide Flange Nut
Cross Brace Installation for
48” Leg Packages
1004 East Illinois Street • Assumption, IL 62510 • 1–217–226–4421
Date:2–16–12
Printed in the U.S.A.
Copyright 2012 by GSI Group
www.gsiag.com
PNEG-1860
PNEG-1860
Page 5