Grain Systems Unload Augers PNEG-1060 - Manual (Page 13)

PNEG-1060 6", 8" and 10" Variable Angle Auger Connector 13
5. Assembly Instructions
1. Connect the inlet stub to the bin unloading flight.
2. Connect the box weldment inlet flange to the unloading tube flange using the quick clamp or by
directly bolting them together. (NOTE: If you have a 6" to 8" or 8" to 10" VAAC, bolt the adapter
plate to the box weldment inlet flange before attaching to the bin unloading tube flange.)
3. Remove cover strap.
4. Attach the incline auger flight to the discharge connecting stub.
5. Fasten the outlet tube to the inclined auger tube using the connecting band.
6. Once the angle of the auger is adjusted, support auger with one of the options shown on Page 11 .
7. Replace cover strap over the lid and tighten.
Figure 5A