Grain Systems PNEG-1786 - Manual

Date: 12-28-10 PNEG-1786
Instructions
1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421
PNEG-1786
Page 1 of 2
Printed in the U.S.A.
Copyright © 2010 by GSI Group
www.gsiag.com
Shinko Controller
Setup (056-1954-9)
Introduction
Depending on the input settings, the Shinko Controller (056-1954-9) can be set up for three (3) possible
configurations. Refer to charts
on Page 2 for the input settings to designate the controller.
Instructions
Figure 1
Programming Sub Setting Mode
1. Power-up the unit.
2. Press UP ARROW and simultaneously press the MODE KEY (Basic Setting Mode).
3. Use arrow keys to change the setting values.
4. Set setting values for the controller type according the programming table.
5. Press MODE KEY to enter setting and step to the next function.
6. Repeat Step 3 through Step 5 until all modes “PROP BAND” through “PROP CYCLE” are
properly set.
Programming Auxiliary Function Mode 2
7. Simultaneously press DOWN ARROW and the MODE KEY for approximately 3 second or until
“Loct” is displayed (Auxiliary Setting Mode).
8. Repeat Step 3 through Step 5 until all modes “VALUE LOC” through “OUTPUT HYST” are set.
NOTE: Basic setting modes cannot be changed when the value lock is set as 1, 2 or 3.
9. Change lock value to “LOCK 2” when finished programming.