Installation, Chapter 3 installation, Removal and installation – Grain Systems Unload Augers PNEG-1716 User Manual
Page 9
Advertising
PNEG-1716 Gearbox Input Speed Reduction Packages
9
3. Installation
Removal and Installation
1. Remove the two (2) 5/16" serrated flange nuts that retain the inspection cover as shown in
.
Figure 3A
2. Remove the inspection cover from the center well.
3. Unhook the idler sprocket tension spring from the idler sprocket bracket.
4. Rotate the idler sprocket bracket away from the chain.
5. Slide the clutch yoke driving jaw away from the clutch sprocket driven jaw as shown in
.
Figure 3B
Advertising