Grain Systems Bin Flooring PNEG-218 - Manual (Page 26)

26 PNEG-218 30' Cor-Lok and Cut-Lok Flooring
10. Flashing Support at Stiffeners
Stiffener Flashing Support Instructions for Internal
Universal Stiffeners
1. Install the floor and support system, cutting the floor to go around the internal stiffeners as required.
2. Break the stiffener flashing support (SS-6984) into its three (3) components.
3. Lay the flashing supports on top of the flooring and weld the flashing supports to the stiffener as
close as possible. Fasten the flashing to the wall, flashing support, and floor. Seal all spaces by
welding or caulking.
4. Paint all welds with good quality zinc rich paint.
5. Stiffener flashing supports (SS-6984) must be ordered separately from the standard floor
and flashing.
Figure 10A