Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1385 - Manual (Page 14)

4. Maintenance
14 PNEG-1385 Farm/Commercial Distributor
Replacing the Wear Liner (Continued)
Position the spouting near the door. Remove the transition extension tube. (See Figure 4A on Page 12.)
Remove the transition spout. (See Figure 4A on Page 12.) Reverse the transition box which will allow
access to the hardware holding the liner in. (See Figure 4B on Page 13) . Replace the old liner with the
new liner. (See Figure 4C on Page 13.) Replace the transition spout and transition extension tube.
Replacement Liner Numbers
6" - DFB0368, 8" - DFB0183, 10" - DFB0051, 12" - DFB0121, 14" - DFB0268
Replacing the Brush Mount Assembly
Position the spouting near the door. Remove the transition extension tube. (See Figure 4D.) Loosen the
clamp band and remove old brush assembly from the transition extension tube. Replace the new brush
assembly onto transition extension tube and tighten in place using the clamp band. Replace the transition
extension tube/brush assembly.
NOTE: Make sure the seam of the brush assembly is facing towards the top as shown in Figure 4D .
The brush bristles should be somewhat snug against the spout wall. Operate the spout to all
outlets to ensure proper alignment and clearance.
Replacement Brush Assembly Numbers
6" - DFB0374, 8" - DFB0189, 10" - DFB0060, 12" - DFB0127, 14" - DFB0274
Figure 4D