Wilwood Tandem Master Cylinder (TM1) - Manual

5/8” TM1 TANDEM MASTER CYLINDER
PART NUMBER: 260-11097
4700 Calle Bolero • Camarillo, CA 93012 Phone 805 / 388-1188 • www.wilwood.com
Installation of this component should ONLY be performed by persons experienced in the installation and proper operation of disc
brake systems. Before installation of the Wilwood TM1 remote tandem master cylinder, read this document carefully to familiarize
yourself with the procedure before beginning. Also, for your reference (on the following pages) is a master cylinder dimensional
and remote setup diagram.
Reservoir Selection:
The reservoirs cannot be mounted directly onto the master cylinder body. The reservoirs must mount in a remote location using
the remote mounting brackets (connected by the hoses included with P/N 260-11098). Always use the clamps provided with the
reservoirs and remote inlet adapters. Do not over tighten.
Mounting Location:
Master cylinder should be firmly mounted to appropriate pedal assembly and kept away from heat sources. Use small hose clamps
to secure hose when remote reservoirs are used. Check to verify that the full stroke of pushrod is unimpeded when depressing
brake pedal and that pushrod is allowed to fully retract when brake pedal is released.
DS-741 REV DATE: 06-09-10
NOTE: Some cleaners may stain or remove the finish on brake system components. Test the cleaner on a hidden
portion of the component before general use.
WARNING
IT IS THE RESPONSIBILITY OF THE PERSON INSTALLING ANY BRAKE COMPONENT OR KIT TO DETERMINE THE SUITABILITY OF THE
COMPONENT OR KIT FOR THAT PARTICULAR APPLICATION. IF YOU ARE NOT SURE HOW TO SAFELY USE THIS BRAKE COMPONENT OR
KIT, YOU SHOULD NOT INSTALL OR USE IT. DO NOT ASSUME ANYTHING. IMPROPERLY INSTALLED OR MAINTAINED BRAKES ARE
DANGEROUS. IF YOU ARE NOT SURE, GET HELP OR RETURN THE PRODUCT. YOU MAY OBTAIN ADDITIONAL INFORMATION AND
TECHNICAL SUPPORT BY CALLING WILWOOD AT (805) 388-1188, OR VISIT OUR WEB SITE AT WWW.WILWOOD.COM. USE OF WILWOOD
TECHNICAL SUPPORT DOES NOT GUARANTEE PROPER INSTALLATION. YOU, OR THE PERSON WHO DOES THE INSTALLATION MUST
KNOW HOW TO PROPERLY USE THIS PRODUCT. IT IS NOT POSSIBLE OVER THE PHONE TO UNDERSTAND OR FORESEE ALL THE ISSUES
THAT MIGHT ARISE IN YOUR INSTALLATION.
RACING EQUIPMENT AND BRAKES MUST BE MAINTAINED AND SHOULD BE CHECKED REGULARLY FOR FATIGUE, DAMAGE, AND WEAR.
WARNING
DO NOT OPERATE ANY VEHICLE ON UNTESTED BRAKES!
SEE MINIMUM TEST PROCEDURE WITHIN
ALWAYS UTILIZE SAFETY RESTRAINT SYSTEMS AND ALL OTHER AVAILABLE SAFETY EQUIPMENT WHILE OPERATING THE VEHICLE
IMPORTANT • READ THE DISCLAIMER OF WARRANTY INCLUDED IN THE KIT