Cobalt Digital COMPASS 9121 3G_HD_SD-SDI_ASI Redundancy Switch - Manual (Page 10)

1
Technical Specifications
1-6 9121 PRODUCT MANUAL 9121-OM (V1.2)
User Control Interface
The 9121 uses DashBoard™ as the normal graphical user interface for the
card, similar to other Cobalt
® Compass
®
or Fusion3G
®
cards.
The DashBoard™ software can be downloaded from the Cobalt Digital Inc.
website: www.cobaltdigital.com (enter “DashBoard” in the search window).
The DashBoard™ user interface is described in Chapter 3,“Operating
Instructions”.
Note: If network remote control is to be used for the frame and the frame has not yet
been set up for remote control, Cobalt ® reference guide Remote Control
User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of Compass
®
cards using DashBoard™. (Cobalt ® OGCP-9000 and OGCP-9000/CC
Remote Control Panel product manuals have complete instructions for setting
up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Documents>
Reference Guides link at www.cobaltdigital.com and then select DashBoard
Remote Control Setup Guide as a download, or contact Cobalt
® as listed in
Contact Cobalt Digital Inc. (p. 1-9).
9121 Rear I/O Modules
The 9121 physically interfaces to system video connections at the rear of its
frame using a Rear I/O Module.
All inputs and outputs shown in the 9121 Functional Block Diagram (Figure
1-1) enter and exit the card via the card edge backplane connector. The
Rear I/O Module breaks out the 9121 card edge connections to BNC
connectors that interface with other components and systems in the signal
chain. See “Installation”, Chapter 2 for Rear I/O Module connections.
Technical Specifications
Table 1-1 lists the technical specifications for the 9121 3G/HD/SD-SDI / ASI
Redundancy Switch card.
Table 1-1 Technical Specifications
Item Characteristic
Part number, nomenclature 9121 3G/HD/SD-SDI / ASI Redundancy Switch
Installation/usage environment Intended for installation and usage in frame meeting openGear™
modular system definition.
Power consumption < 6 Watts maximum
Environmental:
Operating temperature:
Relative humidity (operating or storage): 32° – 104° F (0° – 40° C)
< 95%, non-condensing
Frame communication 10/100 Mbps Ethernet with Auto-MDIX.