Cobalt Digital COMPASS 9381 HD_SD-SDI Timecode Inserter - Manual (Page 43)

9381-OM (V4.3) 9381 PRODUCT MANUAL 3-15
Operating Instructions
9381 Function Submenu List and Descriptions
(continued)
• Mono Mix as Source Mono selection in Source drop-down list allows mono mix content to be
the source for the selected destination Embedded Audio Group channel.
(In this example, the mono content is the source for destination
Embedded Ch 1)
Note: Mono mix content is set up using Mono Mixer Selection in the
Audio Mixing function). Refer to Audio Mixing function
description on page 3-23 for more information.
• LTC Output over Embedded Channel LTC selection in embedded channel Source drop-down list allows any
timecode format received by the card to be outputted as audio LTC over
an embedded audio output (destination) channel.
(In this example, audio LTC is the source for destination Embedded Ch 1)
Note: When LTC is selected as source, Gain and Mute controls are
disabled.
• Tone Generator 1 thru 4 as Source Tone Generator 1 thru Tone Generator 4 range in Source drop-down list
enables one of four tone generators (Tone 1 thru Tone 4) to be the source
for the selected destination Embedded Audio Group channel.
(In this example, Tone 1 (tone generator 1) is the source for destination
Embedded Ch 1)
Note: Tone generator frequencies can be independently set for the four
tone generator sources.
Refer to Tone Generator function description on page 3-23 for
more information.
• Silence (Mute) as Source Silence selection in Source drop-down list mutes the selected destination
Embedded Audio Group channel. Use this setting for unused
destination channels.
(In this example, silence (muting) is applied to Embedded Ch 1)
Table 3-2 9381 Function Submenu List — continued