TC Electronic ComboStaccato - Manual (Page 13)

Remote Control
RH450’s optional remote control – “RC4” – allows for floor recall
of all three MEM-settings as well as mute and tuner display.
11 – TUNER
RH450 is equipped with a fully chromatic, high accuracy bass
tuner. The tuner is always active, whether the RH450 is in Mute
mode or not. Here is how you read the display:
The played note is shown on the left side of the display.
On the right side of the display,
–
a circle indicates that the note is in tune.
– an arrow pointing right indicates that the note is too low and
should be tuned up.
– an arrow pointing left indicates that the note is too high and
should be tuned down.
Too low – tune up Too high – tune down In tune
Sharp notes: C#, D#, F#, G# and A# are indicated as follows:
Example – A#
The tuner also offers a Mute mode with additional tuner
information. To activate Mute mode, simply press the MUTE
button. Now the BASS tone control turns into a high resolution
pitch indicator supporting the Note and Arrow field of the tuner.
Too low – tune up Too high – tune down In tune
Tuner information is also displayed in the optional RC4
footswitch. Yes, this is correct: If you have a RC4 footswitch, you
do no longer need a separate tuner. Please refer to the manual
section “RC4” to learn more about the footswitch.
Tuner Reference
The RH450’s default tuner reference is 440 Hz, like with any
other tuner. However, you can select any reference frequency
between 438 and 445 Hz.
This is how you select the tuner reference frequency:
–
If the RH450 is switched on, switch it off.
– Press and hold the MUTE button during power up.
OPERATION – FRONT PANEL
11
EN