TC Electronic ComboStaccato - Manual (Page 16)

1 – MAINS IN – Power In & POWER switch
The RH450’s auto-sensing switchmode power-supply accepts
any mains voltage from 90 to 240 volts – you do not have to
change settings, fuses or anything else. Simply connect a
standard IEC three pin connector to the local mains voltage, and
you are up and running. This is particularly handy when you use
the RH450 on a tour.
The ground pin of the PSU must be connected in order to
avoid voltage differences between e.g. the PA and the
RH450.
2 – SPEAKER OUT
Use the SPEAKER OUT combo connector for connecting the
RH450 to your cabinet(s). You can use a speaker cable with
either Speakon or ¼" jacks. Do NOT use instrument cables!
The RH450 can be used to drive any cabinet combination of up
to three RS 210/212 units, or any other cabinet combination with
a 4 Ohm minimum load.
OPERATION – REAR PANEL
14
Rear Panel