TC Electronic ComboStaccato - Manual (Page 7)

If you just can’t wait…
Here are a few quick steps to get you playing within minutes
Unpacking
•
Unpack your RH450 amp.
• The box should contain the following items:
–
RH450 amplifier
– Power Cable
– RCA to mini jack cable
– Manual
• Inspect all items for signs of transit damage. In the unlikely
event of this having occurred, inform the carrier and supplier.
• Keep all the packaging if damage has occurred, as this will
show evidence of excessive handling force.
• It is also a good idea to keep the packaging for future
transportation.
Setting up
•
Connect the Speaker Out jack of the amplifier to your
cabinet using a speaker cable. Both Speakon and ¼" jack
cables can be used.
• You can connect up to three RS cabinets or any other two 8
Ohm cabinets of another brand to the amplifier. (minimum
load: 4 Ohm).
• Connect the power cable and power up. The RH450’s
power supply accepts voltages from 100 to 240 VAC.
• Connect your bass to the input jack on the front panel.
• Adjust the input gain using the GAIN knob.
• Adjust the output volume using the MASTER knob.
• Play!
Accessories
The following items can be purchased at your music dealer:
•
RS210 and RS212 cabinets.
• RC4: A pedal with four footswitches that can use to switch
between three memory locations and also to mute for tuning
purposes. This pedal also shows tuner information.
• 19" bracket that allows you to mount the amplifier in a
standard 19" rack.
• Soft bags for both the RH450 amplifier and the RC4.
• Flight cases for the RH450 amplifier and the RC4.
• Flight cases for both RS cabinet models.
Be sure to check www.tcelectronic.com for latest news about
these and other TC products.
QUICK SETUP GUIDE
5
EN