TC Electronic TonePrint Editor - Manual (Page 20)

Modulation parameters
TonePrint Editor 2.0 18
Delay Time 3 parameter
Parameter range: 0.1 to 50 ms
The Delay Time 3 parameter is only applicable
when you have set Modulation Type to TriCho-
rus.
In TriChorus mode, the Delay Time 3 parameter
specifies the length of the delay for the third cho-
rus module.
Feedback parameter
Parameter range: -100 to 100 %
Use the feedback parameter to define the amount
of the signal that is fed back from the modulation
module’s output to its input.
Experiment with the Feedback parameter to get
a feeling for the effects you can achieve.
Feedback HiCut parameter
Parameter range: 20 Hz to 20 kHz
Use the Feedback HiCut parameter to attenuate
the high-end frequencies of the resonance cre-
ated with the Feedback parameter.
Vib. Ramp Time parameter
(Shaker Vibrato only)
Parameter range: 1 to 5000 ms
The Vib(rato) Ramp Time parameter is only avail-
able and editable when a Shaker Vibrato pedal
is connected.
The Vibrato Ramp effect is a subtype of the vi-
brato effect where the effect is latched – i.e., the
effect will only be applied when you press and
hold the pedal’s footswitch. The Vibrato Ramp
Time parameter sets the time that is required for
the vibrato effect to build up.