16-bit timer/counter1 with pwm, 1 features, 2 overview – Rainbow Electronics ATmega64M1 User Manual

Page 103

Advertising
background image

103

8209A–AVR–08/09

ATmega16M1/32M1/64M1

16. 16-bit Timer/Counter1 with PWM

16.1

Features

•

True 16-bit Design (i.e., Allows 16-bit PWM)

•

Two independent Output Compare Units

•

Double Buffered Output Compare Registers

•

One Input Capture Unit

•

Input Capture Noise Canceler

•

Retriggering Function by External Signal (ICP1A or ICP1B)

•

Clear Timer on Compare Match (Auto Reload)

•

Glitch-free, Phase Correct Pulse Width Modulator (PWM)

•

Variable PWM Period

•

Frequency Generator

•

External Event Counter

•

Four independent interrupt Sources (TOV1, OCF1A, OCF1B, and ICF1)

16.2

Overview

The 16-bit Timer/Counter unit allows accurate program execution timing (event management),
wave generation, and signal timing measurement.

Most register and bit references in this section are written in general form. A lower case “n”
replaces the Timer/Counter number, and a lower case “x” replaces the Output Compare unit
channel. However, when using the register or bit defines in a program, the precise form must be
used, i.e., TCNT1 for accessing Timer/Counter1 counter value and so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in

Figure 16-1

. For the actual

placement of I/O pins, refer to

“Pin Descriptions” on page 3

. CPU accessible I/O Registers,

including I/O bits and I/O pins, are shown in bold. The device-specific I/O Register and bit loca-
tions are listed in the

“Register Description” on page 124

.

The PRTIM1 bit in

“Power Reduction Register” on page 39

must be written to zero to enable

Timer/Counter1 module.

Advertising