1 features, 1 lin, 2 uart – Rainbow Electronics ATmega64M1 User Manual

Page 200: 2 overview

Advertising
background image

200

8209A–AVR–08/09

ATmega16M1/32M1/64M1

21. LIN / UART - Local Interconnect Network Controller or UART

21.1

Features

21.1.1

LIN

•

Hardware Implementation of LIN 2.1 (LIN 1.3 Compatibility)

•

Small, CPU Efficient and Independent Master/Slave Routines Based on “LIN Work Flow Concept”

of LIN 2.1 Specification

•

Automatic LIN Header Handling and Filtering of Irrelevant LIN Frames

•

Automatic LIN Response Handling

•

Extended LIN Error Detection and Signaling

•

Hardware Frame Time-out Detection

•

“Break-in-data” Support Capability

•

Automatic Re-synchronization to Ensure Proper Frame Integrity

•

Fully Flexible Extended Frames Support Capabilities

21.1.2

UART

•

Full Duplex Operation (Independent Serial Receive and Transmit Processes)

•

Asynchronous Operation

•

High Resolution Baud Rate Generator

•

Hardware Support of 8 Data Bits, Odd/Even/No Parity Bit, 1 Stop Bit Frames

•

Data Over-Run and Framing Error Detection

21.2

Overview

The LIN (Local Interconnect Network) is a serial communications protocol which efficiently sup-
ports the control of mechatronics nodes in distributed automotive applications. The main
properties of the LIN bus are:

•

Single master with multiple slaves concept

•

Low cost silicon implementation based on common UART/SCI interface

•

Self synchronization in slave node

•

Deterministic signal transmission with signal propagation time computable in advance

•

Low cost single-wire implementation

•

Speed up to 20 Kbit/s.

LIN provides a cost efficient bus communication where the bandwidth and versatility of CAN are
not required. The specification of the line driver/receiver needs to match the ISO9141 NRZ-
standard.

If LIN is not required, the controller alternatively can be programmed as Universal Asynchronous
serial Receiver and Transmitter (UART).

Advertising