Rainbow Electronics GM862-GPS - Manual (Page 68)

GM862-GPS Hardware User Guide
1vv0300728 Rev. 8 - 20/09/07
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 68 of 73
13 Mounting the GM862 module on your
Board
In order to electrically connect your board to the Telit GM862-GPS modules, use a CSTP 2x25 pin
vertical SMD SCH–SCH Molex 53748 - 0504 (female, low profile) as a counterpart to the CSTP 50
pin vertical SMD Molex 52991–0508 (male) of your Telit GM86-GPS.
When mounting the
Telit GM862-GPS on your board, take care of soldering the GM862 shielding reeds
on a ground plane or signal.
Molex 53748-0504 (female, low profile) Connector LAY-OUT
NOTE: be very careful when connecting the
Telit GM862 module RF connector. The Telit GM862
module RF connector can be damaged if not connected with the proper antenna RF connector. The
minimum number of insertion cycles is recommended.