Rainbow Electronics GM862-GPS - Manual (Page 70)

GM862-GPS Hardware User Guide
1vv0300728 Rev. 8 - 20/09/07
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 70 of 73
- Angle connector fixing example 2 -
NOTE: in the examples the cable is always bent, this is not a constrain. If the installation does not
require it, then the cable can be kept straight, ensuring that the fixing is without sliding
.
13.2 Precautions
• The plug should be inserted in the connector only after the installation of the Telit GM862-
GPS modules in the board. This is to prevent accidental breaking of the antenna connection
during the transport.
• The coaxial cable must be fixed at least in one point, without sliding possibilities.
• The plug insertion/removal must be done axially with the female connector of the GM862,
keeping lateral strains to a minimum.
• The insertion/crimping pull out force must be less than 15N.
• The Hole’s diameter for GM862 shielding reed soldering is: (1,5 +/- 0,05) mm