Rainbow Electronics HT49R70A-1 - Manual (Page 37)

SET [m] Set data memory
Description Each bit of the specified data memory is set to 1.
Operation [m] ¬ FFH
Affected flag(s)
TC2 TC1 TO PD OV Z AC C
¾ ¾ ¾ ¾ ¾ ¾ ¾ ¾
SET [m]. i Set bit of data memory
Description Bit i of the specified data memory is set to 1.
Operation [m].i ¬ 1
Affected flag(s)
TC2 TC1 TO PD OV Z AC C
¾ ¾ ¾ ¾ ¾ ¾ ¾ ¾
SIZ [m] Skip if increment data memory is 0
Description The contents of the specified data memory are incremented by 1. If the result is 0, the fol-
lowing instruction, fetched during the current instruction execution, is discarded and a
dummy cycle is replaced to get the proper instruction (2 cycles). Otherwise proceed with
the next instruction (1 cycle).
Operation Skip if ([m]+1)=0, [m] ¬ ([m]+1)
Affected flag(s)
TC2 TC1 TO PD OV Z AC C
¾ ¾ ¾ ¾ ¾ ¾ ¾ ¾
SIZA [m] Increment data memory and place result in ACC, skip if 0
Description The contents of the specified data memory are incremented by 1. If the result is 0, the next
instruction is skipped and the result is stored in the accumulator. The data memory re-
mains unchanged. If the result is 0, the following instruction, fetched during the current in-
struction execution, is discarded and a dummy cycle is replaced to get the proper
instruction (2 cycles). Otherwise proceed with the next instruction (1 cycle).
Operation Skip if ([m]+1)=0, ACC ¬ ([m]+1)
Affected flag(s)
TC2 TC1 TO PD OV Z AC C
¾ ¾ ¾ ¾ ¾ ¾ ¾ ¾
SNZ [m].i Skip if bit i of the data memory is not 0
Description If bit i of the specified data memory is not 0, the next instruction is skipped. If bit i of the data
memory is not 0, the following instruction, fetched during the current instruction execution,
is discarded and a dummy cycle is replaced to get the proper instruction (2 cycles). Other-
wise proceed with the next instruction (1 cycle).
Operation Skip if [m].i ¹0
Affected flag(s)
TC2 TC1 TO PD OV Z AC C
¾ ¾ ¾ ¾ ¾ ¾ ¾ ¾
HT49R70A-1
Rev. 1.00 37 December 4, 2001