Figure c.12: the characteristic of the cable, Figure c.13: system shielding (1) – B&B Electronics ADAM-6066 - Manual User Manual
Page 269
Advertising
259
Appendix C
Figure C.12: The characteristic of the cable
• The characteristic of the cable Don’t strip off too much insulation for
soldering. This could change the effectiveness of the Shielded-Twisted-
Pair cable and open a path to introduce unwanted noise.
Figure C.13: System Shielding (1)
• Shield connection (1)
If you break into a cable, you might get in a hurry to achieve your goal.
As in all electronic circuits, a signal will use the path of least resis- tance.
If we make a poor connection between these two cables we will make a
poor path for the signal. The noise will try to find another path for easier
flow.
Advertising