American Car Craft Hummer H2 Running Light Trim Polished Rear 3Pc 2003-2013 User Manual
Do not get wet for 24 hours
AMERICAN CAR CRAFT INSTRUCTIONS
HUMMER STAINLESS 3pc REAR RUNNING LIGHT TRIM RINGS
PART # 492005
Patent Pending
PARTS INCLUDED:
3-Stainless Running Light Trim Rings
1-Adhesive Promoter Pack
Your new bezels are designed to fit around your rear running lights.
1. You will need to pop your running lights out; this can be done by simply pulling
them. Once they are detached from their locations clean the painted area around
your factory running light openings with household rubbing alcohol to remove
any dirt and wax. Then swipe the area once with the adhesive promoter provided.
2. Peel the red release liner from the back of the stainless rings and carefully set
them evenly around your factory running light openings and press firmly to set.
Push your running lights back into position.
DO NOT GET WET FOR 24 HOURS.
IF ANY QUESTIONS OCCUR DURING INSTALLATION PLEASE CONTACT
AMERICAN CAR CRAFT AT 727-861-1500.