American Car Craft Ford Raptor Headlight Carbon Fiber Wrap 2Pc 2010-2013 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
Raptor Carbon Fiber Headlight Wraps
PART #772003
Parts Included:
2-Carbon Fiber Wraps
1-Adhesive Promoter Pack
1-Felt Squeegee
Introduction: This unique graphic will enhance the body styling of your Raptor with a quality carbon fiber look that is
easy to install and offer a nice custom look
Liner Information: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation.
1. Thoroughly scrub clean the areas of the Raptor body with alcohol to remove any and all wax and dirt.
2. Test that you have done a good job at this by applying ordinary masking tape to a few areas to see if that tape
sticks well. If there is any waxes left the tape will not adhere. If this happens, simply re- clean the area until you
achieve a tack.
3. You have been supplied with and adhesive promoter applicator. This promoter is to be applied to the very rim of
the body line ONLY! This will insure that your new graphic will permanently bond to the paint long term. Do NOT
apply this chemical to the entire body of the graphic area.
4. Now that you have successful prepared your Raptor to receive the graphic place each section into their
appropriate spot to get yourself acquainted with just how they are intended to fit. Draw a cross hair along the