American car craft – American Car Craft Challenger Shock Tower Dome Covers Chrome 2008-2013 User Manual
Page 2
2. The bracket you have just installed will not set exactly flat to the surface do to the
surface shape however the bracket will do the trick after you make some adjustments.
In all cases you will need to pry the outer tab up a little by forcing a flat blade screw
driver under the bracket and raising the bracket tab up a little to allow the tab to work
for the new cover. At this time simply adjust the tabs at both ends of the bracket so that
they will allow the new cover to snap in place. This may take a couple of adjustment
attempts before you get it just right. Once the tabs have been adjusted properly it will
be a simple matter of snapping the new cover on or off as needed. NOTE: The new cover
will have a notch cut from one side. This notch is to face the rear of the car and will
allow the new covers to sit nice and secure into position.
If any questions occur during installation, please contact
American Car Craft at 727-861-1500.
Thank you and enjoy your new purchase!
Note: Care must be taken when cleaning your covers. It is a good idea to
lightly dust your covers with a clean soft cloth first in order to prevent any
particles from scratching them. Then wipe (using a new clean soft cloth)
with a good quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520