American Car Craft Chrysler 300 _ Dodge Charger_Magnum 3.5_5.7_6.1L Shock Tower Dome Covers Chrome 2005-2012 - Manual (Page 2)

1. Remove the factory dome covers if so equipped. You will notice three shock tower
nuts. Remove these nuts and place the stainless attachment bracket over the bolts and
then replace the three nuts and tighten.
2. The bracket you have just installed will not set exactly flat to the surface do to the
surface shape however the bracket will do the trick after you make some adjustments.
In all cases you will need to pry the outer tab up a little by forcing a flat blade screw
driver under the bracket and raising the bracket tab up a little to allow the tab to work
for the new cover. At this time simply adjust the tabs at both ends of the bracket so that
they will allow the new cover to snap in place. This may take a couple of adjustment
attempts before you get it just right. Once the tabs have been adjusted properly it will
be a simple matter of snapping the new cover on or off as needed. NOTE: The new cover
will have a notch cut from one side. This notch is to face the rear of the car and will
allow the new covers to sit nice and secure into position.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
Note: Care must be taken when cleaning your covers. It is a good idea to lightly dust
your covers with a clean soft cloth first in order to prevent any particles from
scratching them. Then wipe (using a new clean soft cloth) with a good quality streak
free glass cleaner.