American Car Craft Corvette Taillight Grilles 4Pc Set - Billet Style 1997-2004 C5 & Z06 - Manual (Page 2)

the factory contoured shape. It is important to know
and understand that the new cover will not just simply
set into place without pre shaping them. It is also
important that you understand that these covers are
made to the near exact size of the light opening in the
bumper and that this opening slightly sets down into a
sort of valley. So in order to properly place them it will
be necessary to set the pre shaped cover down into the
opening and then roll it onto the lenses.
1. Remove all eight factory screws from the taillights. NOTE: These screws will not
be reused.
2. Carefully place each taillight cover into position. Do this slowly so that you do
not scratch your paint. (If you feel more comfortable you can tape the painted
area around your taillights using masking tape before installing your new
stainless covers). NOTE: The lamps tend to move, so if you use something
smaller in diameter then the screws like a “small” Phillips screwdriver to
align everything and then hold it in place prior to installing the new screws, it
will make getting the screws started properly much easier.
3. Once your cover or covers are in position place two of the replacement screws
(provided) thru the white button sockets (provided) and fasten securely being
careful not to over tighten.
4. Snap on chrome screw cap covers (provided).
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!