GlowShift Honda Banjo Bolt Adapter - Manual

For Full Warranty Information Visit GlowShift.com
Honda Banjo Bolt Adapter Installation
1. Remove the stock banjo bolt from the top of the fuel filter housing.

Note: Make sure to remove the “old” crush washers from both sides of the
fuel line.
2. Place the included crush washer on the new banjo bolt adapter then place the fuel
line onto the adapter. After the fuel line is connected to the banjo bolt, place the
second included crush washer onto the banjo bolt adapter to ensure the fuel line is
properly secured and no fuel leaks occur.
3. Thread the banjo bolt adapter into the top of the fuel filter housing.

Note: Do not torque the banjo bolt more than 20 ft. lbs.
4. Install your fuel pressure sensor into the included 90 degree elbow fitting, which
in turn is installed into the female end of the banjo bolt adapter.

Note: Be sure to use Teflon tape on the sensor threads to ensure a tight
seal.