GlowShift Banjo Bolt Adapter - Manual

For Full Warranty Information Visit GlowShift.com
Banjo Bolt Adapter Installation for
1998.5-2007 Dodge Ram with the 5.9L 24-Valve Cummins Diesel
1. Remove your stock banjo bolt from the bottom of the fuel filter housing.

Note: Make sure to remove the “old” crush washers from both sides of the fuel line.
2. Place the included crush washer on the new banjo
bolt adapter then place the fuel line onto the
adapter. After the fuel line is connected to the
banjo bolt, place the second included crush washer
onto the banjo bolt adapter to ensure the fuel line is
properly secured and no fuel leaks occur.
3. Thread the banjo bolt adapter into the bottom of the
fuel filter housing.

Note: Do not torque the banjo bolt more
than 20 ft. lbs.
4. Install your fuel pressure sensor into the snubber
valve which in turn is installed into the female end
of the banjo bolt adapter.

Note: Be sure to use Teflon tape on the
sensor threads to ensure a tight seal.
We recommend installing a snubber valve in line with the
banjo bolt adapter.
The Snubber Valve regulates,
normalizes and eliminates fuel pressure spikes that are
present during the initial ignition and startup of your 86-12
Dodge Ram with a Cummins Diesel Engine. The Snubber Valve manages these high pressure spikes to
by use of a regulator. High pressure fuel system spikes during startup are harmful and may cause early
and unexpected failure of electronic fuel pressure sensors and/or sending units for fuel pressure gauges.