GlowShift Oil Filter Sandwich Adapter - Manual

Oil Filter Sandwich Adapter Installation Instructions
Note: This oil filter sandwich adapter is ONLY for spin on oil filters with a maximum gasket diameter of 3 inches.
1. Disconnect the negative side of your vehicle’s battery.
2. Raise the vehicle using a jack and support it using jack stands.
3. Remove your vehicle’s oil filter and make sure there is enough clearance for the oil filter sandwich adapter.

Note: It may be necessary to adjust some of the wire harnesses in this location in order for the sandwich
adapter to fit.
4. Install your gauge’s temperature or pressure sensors to one of the 1/8 th NPT ports located on the adapter. Install any
other sensors at this time.

Note: If there you are only installing one sensor, use the provided bolts to plug the other open ports.

Note: Be sure to use Teflon tape on all sensor and port plugs to ensure no leaks will occur.
5. Install your GlowShift Oil Filter Sandwich Adapter to the threads where your oil filter is mounted.

Note: Be sure to oil the gasket prior to installing the sandwich adapter.

Note: Do not over tighten the sandwich adapter. If the sandwich adapter is over tightened the gasket that
seals it could tear and result in oil leaks. It should be a little more than hand tight, similar to an oil filter.
6. Install a new oil filter to the threads on the sandwich plate adapter.
7. Once your sandwich adapter is installed with your sensors attached, finish installing the rest of your gauge as per the
included instructions.
8. Reconnect the negative side of your vehicle’s battery.
9. Start the engine and check the sandwich adapter and oil filter for any leaks.