GlowShift 05-08 Chevy Cobalt Triple Gauge Pod - Manual

Effective 4/2013
For Full Warranty Information Please Visit GlowShift.com
05-08 Chevy Cobalt Triple Gauge Pod Installation Instructions
1. Prior to installing this full size gauge pod, be sure that your vehicle does not have side curtain air bags.
2. This gauge pod is a complete replacement and you will have to remove your factory trim.
3. Carefully remove the factory A-pillar trim from your vehicle by removing the bolt located behind the bolt cap.
 We strongly recommend referring to your owner’s manual for the proper procedure on removing this piece.
4. Our gauge pods can be painted using ABS plastic paint. If you decide to paint your gauge pod, be sure to scuff the surface of
the pod using a fine grit sand paper, this will allow the paint to properly adhere to the surface of the pod. Before applying
paint to the gauge pod, make sure that it is cleaned off and there is no residue on the pod from scuffing it.

Be advised, if you decide to paint this pod you will not be eligible to return it for a refund.
5. Use a scoring tool, measure and mark the location of the factory screw location on the gauge pod.
6. Using a 1/8 th inch drill bit, drill a hole through the gauge pod where you just marked with the scoring tool.
7. Install your gauges into the pod by following the instructions that are included with them.
8. Connect the gauge wires to the power and sensor wires as per the instructions that are included with your gauges
9. Install the gauge pod to you factory A-pillar using the provided screw. This screw installs directly into the threads that your
factory trim screws into.
10. To ensure a proper fit, screw the bolt into the threads but do not completely tighten it. Adjust the gauge pod so that it lines up
correctly and then tighten the bolt.