Peterson AutoStrobe 490ST - Manual (Page 12)

Page 10
+
7
ч
+
7
ч
+
7
ч
Button #1 returns to the Setup menu.
Button #2 saves new values and returns to the SETUP menu.
Button #3 returns to RUN screen and uses new values
(new values are not put into startup memory with #3).
RECALIBRATE TUNER?
NOW A= XXX
NEXT RUN DOWN UP
1 2 3 4
1
KEY SETTING
KEY IS NOW : X
NEXT RUN
1 2 3 4
Accessing the Key Setting Screen
The KEY screen uses the front panel KEY button to alter the KEY setting just as it will under the RUN screen.
KEY SETTING
KEY IS NOW : X
NEXT RUN
1 2 3 4
1
AUTO–NOTE SETTING
MODE IS NOW : XXX
NEXT RUN OFF ON
1 2 3 4
Accessing the Auto-Note Setting Screen
Finally, hitting the “1” button (NEXT) under the Auto-Note SETUP screen activates the Memory Store screen:
AUTO–NOTE SETTING
MODE IS NOW : XXX
NEXT RUN OFF ON
1 2 3 4
1
STORE VALUES IN
SYSTEM MEMORY?
NO YES RUN
1 2 3 4
Accessing the Parameter Memory Storage Screen
STORE VALUES IN
SYSTEM MEMORY?
NO YES RUN
1 2 3 4
Pressing the “1” button (NO) at this time will cause no changes in stored memory and revert back to the SETUP menu screen.
Pressing the “3” button (RUN) at this time will cause no changes in stored memory and revert back to the normal RUN
screen.