Peterson AutoStrobe 490ST User Manual
Page 24
Page 30
+
7
ч
+
7
ч
+
7
ч
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B G _
< — — — — > BKSP
CNCL
1
2
3
4
1
(Press and hold)
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B G _
< — — — — > BKSP
CNCL
1
2
3
4
Selecting the Final Character To Enter Into the New Stretch File Name
And, finally:
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B G _
< — — — — > BKSP
CNCL
1
2
3
4
ENTER
THE NAME CHOSEN FOR
STRETCH IS: BG 1
REDO OK CNCL
1
2
3
4
Entering the Final Character Into the New Stretch File Name
You may briefly see the PICK NAME screen updated with the final name character, but this new “verify” screen will appear
as soon as you release the ENTER button at this point. On the flowchart, we have now exited the loop defined by the
“4 characters?” decision box; in other words, since we have now entered four characters into our stretch file name we now
exit through the path labeled “YES” (in answer to the “4 characters?” question). Note that, at any time up to this point, if
we had mistakenly entered an incorrect character, we could have hit the “3” button (BKSP) to backspace through the last
character entered into the name at the time. Backspacing and entering characters can be repeated indefinitely until the fourth
name character is entered and this final verify screen is activated. We still have an opportunity to start completely from
scratch in naming our stretch file by hitting the “1” (REDO) button at this point. We may also cancel the entire stretch
creation process and return to the RUN screen with no permanent changes by pressing the “3” (CNCL) button.
Typically, however, being confident and consummate professionals, we will press “2” to OK our selection:
THE NAME CHOSEN FOR
STRETCH IS: BG 1
REDO OK CNCL
1
2
3
4
2
STRCH = BG 1 KEY= C
NOTE= C 00. 0 ¢
OCTV= 4
DONE NEXT
1
2
3
4
Verify Stretch File Name and Begin Note Editing
NOTE: If you had chosen either a name that you have already used and stored in the unit or a name used as one of the
factory defaults, a different screen will be activated which indicates the problem and permits you to return to the STRETCH
MENU screen with no changes. You must then decide which course of action you wish to take: proceed with creating a
stretch file with a different name or delete the previously created user file and then create your new stretch file using this
original name.