Peterson AutoStrobe 490ST - Manual (Page 22)

Page 28
+
7
ч
+
7
ч
+
7
ч
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=_ _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
2
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=_ _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
Selecting a Character To Enter Into the New Stretch File Name
The cursor underline is now under the “B” in the selection string, but no character has been added to the stretch file name.
To do this we must press the ENTER button on the front panel. (Note our position in the flowchart.)
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=_ _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
ENTER
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
Entering a Selected Character Into the New Stretch File Name
Notice that a “B” character has now been entered into the first of the four Stretch File name positions. Also note that we
remain on the PICK NAME screen at this time. All file names must have exactly 4 characters (although any number of the
four may be the “blank” character), and the tuner will remain on this selection screen until we have selected a character for
all four positions in the name field area (or, alternatively, if we opt to cancel (CNCL) the whole operation with button “4”).
In order to advance the cursor to fall under the “G” (in anticipation of our next character selection), we could press the “2”
button five times in quick succession. Alternatively, if the “2” button is held in the pressed position, the cursor will advance
automatically one character at a time and several times a second. (This same hold feature is present on the “1” button when
reversing the cursor.) This is typically how we would advance the cursor any time we would need to move the cursor by
more than two or three characters.
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
2
(Press and hold)
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 STRCH=B _ _ _
< — — — — > BKSP
CNCL
1 2 3 4
Selecting the Second Character To Enter Into the New Stretch File Name
Once again, we must press the ENTER button to actually add our selection to the Stretch File name: