Peterson StroboPlus HD Owners Manual User Manual
Page 11
Presets
Creating a New Preset
When your tuner displays a combination of Sweetener, Hz and Transpose values that you wish to save as a preset,
press and hold the preset/store button until the word “Preset”, a number, and the word ADD or SAV (“save”)
appear. If other presets have already been saved and you wish to create an additional one, turn the encoder knob
until the word “ADD” instead of “SAV” is shown. This will also display a preset number that has not already been
used. Press the preset/ store button again to confirm. The display will briefly show a circular animation to indicate
that your StroboPlus is saving your preset.
Overwriting an Existing Preset
To store the displayed combination of Sweetener, Hz and Transpose values by overwriting the values already
assigned to a particular preset number, press and hold the preset/store button for two seconds. Rotate the encoder
knob until the preset number you wish to edit is displayed, along with the abbreviated word “SAV”. Press the
preset/ store button momentarily. A circular animation indicates that your values are saved to that preset number.
Deleting an Existing Preset
To delete a preset that was previously created, momentarily press the preset/ store button. Rotate the encoder
knob to display the preset number that you wish to delete, then press and hold the encoder knob for a few seconds.
The abbreviated word “DEL” will appear for a few seconds as you continue to hold the knob. When “DEL”
disappears, your preset will have been deleted and all higher-numbered preset combinations shifted to a lower
preset number accordingly.
Recalling a Preset for Use
To use a combination of Sweetener, Hz and Transpose values that was previously saved as a preset on your
StroboPlus, momentarily press the preset/ store button. Turn the encoder knob to display the preset number you
wish to recall. A moment after you stop turning the encoder knob, the display will change from the preset number
to the values associated with that preset. To begin using those values, simply wait a few seconds without turning
or pressing the encoder knob, or to immediately accept the displayed values momentarily press the power button
once. Presets can also be created on a computer for downloading by visiting