Peterson StroboPlus HD Owners Manual - Manual (Page 12)

Audio Tuner Mode
Your StroboPlus™ has a built-in speaker and a headphone audio output for use as an audio tone generator. To use
this feature, press the mode button once or twice until only the far right and far left sides of the strobe pattern are
shown. The manual note select mode is automatically activated to let you choose your desired note and octave. In
order to begin hearing the tone or stop the tone output, press the start button.
Note: It is possible to select both the note and the octave from the edit menu when in manual note select mode.
All other settings, such as Transpose, Concert A and Sweeteners™/Temperaments are also selectable for your
audio tuner from the edit menu.
The speaker is disabled when a plug is inserted into the headphone output.
The tone/voice that is heard can be selected by editing the voice selection.
Configuration Menu
This menu is used to reset your StroboPlus to factory default settings and to determine the firmware and hardware
version. To enter the configuration menu press the power button and the mode button at the same time.
The first setting to show will be C, indicating the configuration currently loaded.
FDR= Factory Default Reset
USR= User configured. This indicates that there has been a user configuration created on the PetersonConnect™
site and loaded to the device. To return to the factory default, select FDR with the selector knob and press in. If
only dashes “-- -- --“ are shown there is no user configuration on your tuner.
Rotating the selector knob will next show F and the firmware that is currently installed in your tuner. There will
be three numbers displayed; combined they indicate the installed firmware version.
H indicates the hardware version of the tuner.
To exit this menu, press the mode button.