Peerless-AV HLG452-PH-Q10 - Installation - Manual (Page 4)

ISSUED: 08-25-09 SHEET #: 090-9188-3 09-14-11
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
4 of 5
BOTTOM OF
DESKTOP
4
D
B
FIG 4.1
C
B
TIGHTENING
SLOPE NUT
Hand tighten slope nut ( D) through 1/4-20 x 1 3/4"
screw bolt ( B) until snug against bottom of desktop
surface. Thread another slope nut ( D) upside-down,
about two turns from first slope nut ( D). Insert an
open box wrench between both slope nuts ( D) and
tighten. NOTE: Avoid jamming both slope nuts (D)
together, doing so may make it difficult to remove
slope nut used for tightening first slope nut ( D). After
slope nut is secure remove bottom slope nut and add
plastic cap ( C) as shown in figure 4.2. Repeat with
remaining 1/4-20 x 1 3/4" screw bolt ( B).
FIG 4.2
RUBBER FEET
Attach lock-down plate to display base bottom using
screws provided by manufacturer. Refer to page three
for lock-down plate/ display base stand hole pattern.
NOTE: Remove existing rubber feet from display base
that interfere with the lock-down plate.
NOTE: Display base stand and mounting
hole locations may appear different than
illustrated.
DISPLAY BASE STAND
A
3
SCREWS SUPPLIED BY
MANUFACTURER