Peerless-AV PJF2-UNV-S - Installation - Manual (Page 9)

ISSUED: 01-14-09 SHEET #: 056-9018-2 05-18-10
Visit the Peerless Web Site at www.peerlessmounts.com
9 of 9
For customer care call 1-800-729-0307 or 708-865-8870.
To adjust roll, pitch, and yaw loosen the set screw
(shown below) using security allen wrench ( U) or
standard 4 mm allen wrench. You should be able to just
slightly loosen the screw so that your adjustments can
be set without having to hold the projector. Move projec-
tor to desired position and slowly tighten set screw.
NOTE: Be sure not to touch the projector while tight-
ening the set screw. This may cause the image to be
unaligned when you let go.
IMPORTANT: Allen wrench is your key for projector
removal. Store it in a safe place.
Attach projector, with adapter plate ( B) already on it, to
the ball and socket mount ( A) by inserting the ball and
socket mount into the adapter plate connection and
twisting until the adapter plate will no longer turn (about
75°). The spring loaded captive screw should line up
with a corresponding hole on the adapter plate (this
should line up automatically when the two are connect-
ed). Push down and tighten the spring loaded captive
screw to secure the adapter plate to the mount. If not
using the optional security feature, fasten thumb screw
( F) in the hole opposite the spring loaded captive screw.
OPTIONAL: For Armor Lock ™ security, insert serrated
washer head socket pin security screw ( G) in the hole
opposite the spring loaded captive screw. Tighten with
security allen wrench ( U). This will prevent the projector
from being removed.
NOTE: Be sure to only use the #10-32 x 3/8"
screw (G) (or the thumb screw (F)) opposite the
spring loaded captive screw.
A
WOOD
JOIST
CEILINg
PROJECTOR
ADAPTER PLATE
PROJECTOR
WOOD JOIST
CEILINg
PROJECTOR
CUTAWAY VIEW OF
CEILINg PLATE ( C)
G
2
1
F
• Do not lift more weight than you can handle! Use ad-
ditional man power or mechanical lifting equipment to
safely handle placement of the projector!
WARNING
7 8
© 2009 Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Attaching Adapter Plate to Projector Mount
B
SET SCREW
CAPTIVE
SCREW