Peerless-AV HT642-004 - Installation - Manual (Page 8)

8 of 10 ISSUED: 09-20-11 SHEET #: 125-9245-1
BACK OF DISPLAY
E or N
O
NOTE: When using M6 x 16
socket pin screw ( E), you
must use nylon washer ( O).
MOUNTING HOLE LOCATIONS
A
B
DISPLAY
DISPLAY
3
Using information provided in detail 1 secure two adapter brackets ( A and B) to back of display with four M6 x 16
mm socket pin screws ( E) and nylon shoulder washers (O), or four M8 x 10 mm socket pin screws (N) using 18"
long 4 mm allen wrench ( G).
NOTE: Make sure that screws are centered in hole in adapter brackets.
Attach dual lock ( M) to back of adapter brackets (A and B) as shown below.
Attach component to dual lock as shown.
COMPONENT
NOTE: MAKE SURE THAT
COMPONENT CABLES
RUN AS SHOWN
2
Attaching Component to Adapter Brackets
Attaching Adapter Brackets using VESA 200 x 200 Mounting Pattern