Fi g. 7.2, Fi g. 7.1 – Peerless-AV PLA50-UNLP-GB - Installation User Manual

Page 11

Advertising

11 of 41

ISSUED: 06-05-06 SHEET #: 202-9140-10 (2013-10-01)

Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE:

Spacers may not be used, depending upon the type of display.

Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

7-1

7-2

If you have any questions, please call Peerless customer care at 1-800-865-2112.

DISPLAY

MULTI-WASHER

SCREW

ADAPTER
BRACKET

(BB)

fi g. 7.2

SPACER

fi g. 7.1