Hotpoint Ariston CE6IFA.T X F-HA S User Manual
Page 30
30
GB
4. Set the cooking duration using the
-----
and
+
+
+
+
+
buttons.
5. Confirm by pressing the
button or automatic
selection occurs after 10 seconds.
The timer begins counting down immediately. A buzzer
sounds for approximately 1 minute and the cooking zone
switches off when the set programme has finished.
Repeat the above procedure for each hotplate you wish to
programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the display will
show the data for the hotplate with the least time
remaining, and the light corresponding to the position of
the hotplate will flash. The lights corresponding to the other
hotplates programmed will be switched on.
To visualise the time remaining for the other programmed
hotplates, press the
button
repeatedly: the time remaining for each
hotplate will be shown sequentially in a
clockwise order, starting from the front left
hotplate.
Changing the programme
1. Press the
button repeatedly until the duration you
wish to change is shown.
2. Use the
buttons to set the new duration.
3. Confirm by pressing the
button.
To cancel a programme, follow the above instructions. At step
2, press the
-----
button: the duration decreases progressively
until it reaches 0 and switches off. The programme resets and
the display exits programming mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99 minutes.
1. Press the
programming button until the timer
indicator light is illuminated
.
2. Set the desired duration using the
-----
and
+
+
+
+
+
buttons.
3. Confirm by pressing the
button.
The timer begins counting down immediately. When the
time has elapsed, a buzzer will sound (for one minute).
Control panel lock
When the hob is switched on, it is possible to lock the
oven controls in order to avoid accidental changes being
made to the settings (by children, during cleaning, etc.).
Press the
button to lock the control panel: the
indicator light above the button will switch on.
To use any of the controls (e.g. to stop cooking), you must
switch off this function. Press the
button for a few
moments, the indicator light will switch off and the lock
function will be removed.
Switching off the hob
Press the button
to switch off the appliance - do not
rely solely on the pan sensor.
If the control panel lock has been activated, the controls
will continue to be locked even after the hob is switched on
again. In order to switch the hob on again, you must first
remove the lock function.
“Demo” mode
It is possible to set the hob to a demonstration mode
where all the controls work normally but the heating
elements do not switch on. To activate the “demo” mode
the hob must be switched on, with all the hotplates
switched off.
• Press and hold the
+
+
+
+
+
and
-----
buttons simultaneously
for 6 seconds. When the 6 seconds have elapsed, the
ON/OFF and CONTROLS LOCKED indicator lights will
flash for one second. Release the
+
+
+
+
+
and
-----
buttons
and press the
button;
• The display will show the text DE and MO and the hob
will be switched off.
• When the hob is switched on again it will be set to the
“demo” mode.
To exit this mode, follow the procedure described above.
The display will show the text DE and OF and the hob will
be switched off. When it is next switched on, the hob will
function normally.
Practical advice on using the appliance
! Use cookware made from materials which are compatible
with the induction principle (ferromagnetic material). We
especially recommend pans made from: cast iron, coated
steel or special stainless steel adapted for induction. Use
a magnet to test the compatibility of the cookware.