Hotpoint Ariston CE6IFA.T X F-HA S - Manual (Page 35)

GB
35
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
• It is usually enough to wash the hob with a damp
sponge and dry it with absorbent kitchen roll.
• If the hob is particularly dirty, rub with a special
glass ceramic cleaning product, rinse and dry.
• food residue and dirt can be removed using a
special scraper. Do this as soon as possible, do
not wait for the hob to cool down in order to avoid
incrustations. For excellent results, use a special
stainless steel wool pad for vitroceramic glass
cleaning soaked in soapy water.
• If plastic or sugary substances are accidentally
melted on the hob, remove them immediately with
the scraper, while the surface is still hot.
• Once it is clean, the hob may be treated with a
special maintenance and protection product: the
invisible film left by this product protects the
surface from drips during cooking. This should be
done while the appliance is warm or cold.
• Always remember to rinse the appliance with
clean water and dry the hob thoroughly: residues
can become encrusted during cooking.
Inspecting the oven seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Authorised After-sales Service Centre.
We recommend that the oven is not used until the
seals have been replaced.
Replacing the oven light bulb
To replace the
oven light bulb:
1. Remove the glass cover using a screwdriver.
2. Unscrew the light bulb and replace it with a
similar one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly (
see diagram).
Care and maintenance
Glass door
Seal
Lamp
Oven
compartment
Hobs CE6IFA.T X F/HA S
Cooking zone Power (W)
Back Left I 1400
Back Right I 3000 – B 4000
Front Left I 2200
Total power 7600
Technical description of the models
The induction system is the quickest existing way of
cooking. Unlike traditional hotplates where the
cooking zone heats up, with the induction system
heat is generated directly inside pans which have
ferromagnetic bases.
Key:
I = single induction cooking zone
B = booster: the power level of the cooking zone
may be boosted to 3000 W
* = the maximum power level is limited while the
booster is activated for the relevant rear cooking
zone (see
Start-up and use).
! Do not use the oven lamp as/for ambient
l i g h t i n g .