Ingalls 93045 - Manual (Page 2)

© Ingalls Engineering Co., Inc. - 2011 Cherry Street, Suite 104 - Louisville, CO, 80027
(800) 641-9795 - (303) 665-7800 - Fax: (303) 665-7810 - www.IngallsEng.com
Illustration 3 Illustration 4
Step 3: Install Stiffy™ onto Engine Mount Bracket using the supplied hardware. You may need to loosen the jam nut with an open-
end wrench (17mm) and adjustable wrench to increase the assembly length depending upon application. The supplied M10
(17mm HEX) bolt should go through from the fender side of the bracket, and the Stiffy ™ should mount on the engine side of the
bracket. The supplied rubber o-ring is placed between the Stiffy™ rod end and the supplied washer (smaller washers), which
mounts against the bracket. The Stiffy™ nuts (15mm HEX) are black in color, where all other supplied nuts are silver in color. The
Stiffy ™ adjustment dials should be facing toward the Chassis Mounting Bracket.
Notes:
Proper use and fitment of the rubber O-ring helps dampen additional road noise or “feel” that can be transferred through the damper assembly. The
O-ring should be used between the Stiffy ™ heim joint and bracket for optimal noise suppression. Dynamat or other damping materials, as used in
aftermarket audio and in-car electronics industries, can also be used to provide further noise and vibration damping when used between the
brackets and the surface they mount on.
DO NOT attempt to adjust Stiffy ™ from its pre-set stiffness without consulting the Ingalls website. Large open-end wrenches are required to adjust
stiffness (27mm). Most standard and mechanics tool kits do not include these types of wrenches.
Limited Warranty
Subject to Disclaimer. All Ingalls Engineering Co., Inc. products are warranted against defects in materials and workmanship for ninety (90) days from date of purchase. During the
warranty period Ingalls will repair, or at its option replace, at no charge components that prove to be defective. The product must be returned, shipping prepaid, to Ingalls facility. This
limited warranty does not apply if the product is damaged by accident of misuse. The foregoing warranty is in lieu of all other warranties expressed or implied; including but not
limited to any implied warranty of merchantability, fitness, or adequacy for any other particular purpose or use. Ingalls shall not be liable for any special, incidental, or consequential
damages whether in contract, tort, or otherwise resulting from the use or the inability to use the product.
Warranty Disclaimer
Use of this product in competition, or use on vehicles altered from original manufacturer’s specifications or settings, EXPRESSLY VOIDS WARRANTY. The user is urged to inspect
for suspension binding or interference when the product is used in these manners. However, due to the varying conditions and manner of which the product will be subjected to in
such uses, Ingalls Engineering Co., Inc. makes no warranties, either express or implied, including any warranty of merchantability or fitness for a particular purpose for use in
competition or with specification or settings other than those specified by the original manufacturer’s specifications.
This image shows how the Stiffy™ should look after
installation. The brackets should be aligned so that the
Stiffy™ is parallel to the valve cover. If need be, you can
use spacers or washers to ensure that the Stiffy™ will be
properly aligned. Make sure however that the rubber o-
ring is against the heim joint for noise suppression.